Installation Video
1) Tap the installation button on the app.
If you see a prompt on your screen follow the instructions and then hit continue.
2) Move the pin to the desired location of installation and tap "PLACE HERE"
3) You will now have two options, either press the plus button in the top right, you will see the option to create a new area. The other option is to select one of your pre-existing areas and assign the sensor there
4) Pull the magnet off the sensor.
You should observe white blinks followed by green light after 30 seconds to 2 minutes. This means that the sensor connected successfully.
**If you see a red light, it is recommended you place the magnet on again for 10 minutes & remove
5) Follow prompts to install your sensor.
The app will ask to use camera features, select the option to allow. A screen will then pop-up to scan the QR code on the side of your sensor. Press accept and then you will receive a prompt to wait for the first connection of your sensor please wait until the system verifies your connection.
**If you do not have a working camera on your device you can tap "Enter ID Instead" to install your sensor
6) If the system does not say that your first data point has been verified, replace the magnet on to the top of the sensor and wait 30 seconds. Once you have waited remove the magnet again and the system will verify your sensor.