Before Beginning the Installation of your new or relocated Spiio Sensor, it is highly suggested you perform a general location connection quality test to verify the connection strength of the sensor in the decided location!
Using a Sensor and the Spiio Live App on your mobile phone:
Open your Settings Panel
Select "Location Quality Test"
Proceed by following the Instructions prompted by the mobile app:
Scan the Sensor
After pressing continue you will be asked to scan the QR code off the sensor
Head to first test location
Testing multiple locations will give you a better picturePlace Sensor on ground level
Sensor should be as close as possible to the installation location
Start Sensor by removing the magnet
Remove magnet to start the sensor. Wait for white blinks followed by green blinks
Check Location quality
Rendered in the mobile application screenRestart Sensor to repeat
Apply the magnet for 30 sec and restart it to conduct another test at the same location or others.
NOTE: If any of the readings show a 'BAD' quality readings we DO NOT recommend installing in this location. As a 'BAD' quality reading above ground will have reduced signal strength when the sensor is installed.
Testing multiple locations of an install area.
It is sometimes useful to take multiple points of an area, such as a golf course green to make a quadrant of signal test areas to document and find the most optimal signal strength area such as the visual below.
